Vol. 5 No. 3 (2019): IJCESEN

Research Article

• Experimental Investigation of Surface Roughness of Cutting Parameters in T6 Aluminum Alloy Milling Process

  Neslihan ÖZSOY

  105-111

  • PDF

• The Effect of Exhaust Temperature on Urea-Water Decomposition in Marine SCR Systems

  Kubilay BAYRAMOĞLU, Güner ÖZMEN, A. Güldem CERİT

  112-118

  • PDF

• Determination of the Radiation Dose Level in Different Slice Computerized Tomography

  Osman GÜNAY, Özcan GÜNDOĞDU, Mustafa DEMİR, Mohammad ABUQBEİTAH, Doğan YAŞAR, Serpil AKÖZCAN, Enis KAPDAN, Onur YARAR

  119-123

  • PDF

• Optimization of Air Distribution in A Non-Ducted Concealed Type Fancoil Unit Heat Exchanger

  Murat OZSOY , Canberk YUCEL, Onur VARLICA, Serhan KILIÇ, Kagan KAPLAN

  124-130

  • PDF

• Research and application of DCA microspheres as deep profile control agent in low permeability reservoir

  Xuedong SHİ , Xiang’an YUE, Mingda DONG, Changchun YANG

  131-134

  • PDF

• Investigation From Different Calculation Solutions In Vertebra Plans And The Reliability Of Different Dose Rate Dose

  Yonca Yahşi ÇELEN, Hazım Orhan KIZILKAYA

  135-138

  • PDF

• Vibration Behavior of Composite Materials Produced by Waste Metal Recycling

  Aydın GÜNEŞ, Erdi GÜLBAHÇE, Emin SALUR, Abdullah ASLAN, Ömer Sinan ŞAHİN

  139-141

  • PDF

• Investigation of The Effect of Intermediate Dose Calculation Module on Dose Dıstrıbutıon in Lung Cancer Radiotherapy Patients

  Yonca YAHŞİ ÇELEN, Hazım Orhan KIZILKAYA

  142-146

  • PDF

• Comparing the Effect of Process Fluid for Wet Ground Heat Exchanger

  Ufuk DURMAZ, Orhan YALÇINKAYA

  147-150

  • PDF

• Recycling and Characterization of Metallic Chips Using Powder Metallurgy

  Handan DEMİREL, Aydın GÜNEŞ , Ömer Sinan ŞAHİN

  151-153

  • PDF